Nokia 7330 - Aggregate; Table 623 Aggregate Command

Virtual Private Routed Network Service
572
FD 100/320Gbps NT and FX NT IHub Services Guide
3HH-11985-AAAA-TQZZA Issue: 13
7.10.12.16 aggregate
Table 623 aggregate command
Table 624 describes the command output fields.
Flags Specifies the conditions that affect the operating status of this SAP.
Display output includes: ServiceAdminDown, SapAdminDown,
InterfaceAdminDown, PortOperDown, PortMTUTooSmall, L2OperDown,
SapIngressQoSMismatch, SapEgressQoSMismatch, RelearnLimitExceeded,
RxProtSrcMac, ParentIfAdminDown, NoSapIpipeCeIpAddr, TodResourceUnavail,
TodMssResourceUnavail, SapParamMismatch, CemSapNoEcidOrMacAddr,
StandByForMcRing, ServiceMTUTooSmall, SapIngressNamedPoolMismatch,
SapEgressNamedPoolMismatch, NoSapEpipeRingNode, mcStandby (22),
mhStandby (23), oamDownMepFault (24), oamUpMepFault (25),
ethTunTagMisconfig (26), ingressPolicerMismatch (27), egressPolicerMismatch
(28), sapTl.
Last Status Change Specifies the time of the most recent operating status change to this SAP.
Last Mgmt Change Specifies the time of the most recent management-initiated change to this SAP.
Admin MTU The desired largest service frame size (in octets) that can be transmitted through the
SAP to the far-end router, without requiring the packet to be fragmented.
Oper MTU The actual largest service frame size (in octets) that can be transmitted through the
SAP to the far-end router, without requiring the packet to be fragmented.
Ingress Filter-Id The ingress filter policy ID assigned to the SAP.
Egress Filter-Id The egress filter policy ID assigned to the SAP.
Acct. Pol The accounting policy ID assigned to the SAP.
Collect Stats Specifies whether statistics collection is enabled.
Forwarding Engine Stats
Dropped The number of packets and octets dropped due to SAP state, ingress MAC or IP
filter, same segment discard, bad checksum, etc.
Label Description
(2 of 2)
Item Description
Syntax aggregate [family] [active]
Context show>router
Description This command displays aggregated routes.
Parameters family — Specifies the address family to be displayed.
Values: ipv4 — Displays only those aggregate routes that are IPv4-capable.
ipv6 — Displays only those aggregate routes that are IPv6-capable.
active — This keyword filters out inactive aggregates (only active aggregates are displayed).