Nokia 7330 - Table 244 Send-Queries Command; Table 245 Static Command

FD 100/320Gbps NT and FX NT IHub Services Guide Virtual Private LAN Service
Issue: 13 3HH-11985-AAAA-TQZZA 315
5.16.6.10 send-queries
Table 244 send-queries command
5.16.6.11 static
Table 245 static command
Item Description
Syntax [no] send-queries
Context configure>service>vpls>sap>igmp-snooping
Description This command specifies whether to send IGMP general query messages on the SAP.
When send-queries is configured, all type of queries generated ourselves are of the
configured version.
If a report of a version higher than the configured version is received, the report will get
dropped and a new wrong version counter will get incremented.
If send-queries is not configured, the version command has no effect. The version used on
that SAP will be the version of the querier. This implies that, for example, when we have a v2
querier, we will never send out a v3 group or group-source specific query when a host wants
to leave a certain group.
Default no send-queries
Item Description
Syntax static
Context configure>service>vpls>igmp-snooping
configure>service>vpls>sap>igmp-snooping
configure>service>mesh-sdp>igmp-snooping
configure>service>spoke-sdp>igmp-snooping
Description This command enables access to the context to configure static group addresses. Static group
addresses can be configured on a VPLS service or an SAP. When present either as a (*, g) or
a (s,g) entry, multicast packets matching the configuration will be forwarded even if no join
message was registered for the specific group.
In case of VPLS service, the data will be forwarded to all interfaces of the given service.
Service level static configuration is applied to all the SAPs associated with the service.
Effective SAP static equals service level static plus SAP level static. Service level static will be
applied to new SAPs automatically. Removal of service static will remove it from all SAPs
associated with the service. Individual SAP level static groups are still applicable even after
removing service level static groups. VPLS service static group helps users to apply a static
group across all SAPs of the VPLS level. A user does not need to configure the static group in
each SAP individually. It is applied to all current SAPs and also new SAPs automatically when
added.