Nokia 7330 - Rid-Check-Disable; Table 347 Rid-Check-Disable Command; Table 348 Icmp Command

FD 100/320Gbps NT and FX NT IHub Services Guide Internet Enhanced Service
Issue: 13 3HH-11985-AAAA-TQZZA 383
6.10.5.8 rid-check-disable
Table 347 rid-check-disable command
6.10.6 IES Interface ICMP Commands
6.10.6.1 icmp
Table 348 icmp command
Description This command enables dynamic host lease state management for IES IP interfaces. Lease
state information is extracted from snooped or relayed DHCP ACK messages to populate lease
state table entries for the IP interface.
If lease state population is enabled and an entry cannot be added to the table, the system will
prevent the far-end host from receiving the DHCP ACK message.
Default lease-populate 16384
Parameters <nbr-of-leases> — This optional parameter defines the number of lease state table entries
allowed for this IP interface. Once the maximum number of entries has been reached,
subsequent lease state entries are not allowed.
The system wide maximum number of leases allowed with all IP interfaces is 24576 including
IPv4 and IPv6 leases.
Values: 1—16384
Item Description
(2 of 2)
Item Description
Syntax rid-check-disable
no rid-check-disable
Context configure>service>ies>if>dhcp
Description This command disables the remote ID check in the interface.
Local Proxy ARP should be enabled in the respective interface.
Default Remote ID check is enabled (no rid-check-disable)
Parameters None
Item Description
Syntax icmp
(1 of 2)