Nokia 7330 - Receive; Table 589 Receive Command; Table 590 Send Command

FD 100/320Gbps NT and FX NT IHub Services Guide Virtual Private Routed Network Service
Issue: 13 3HH-11985-AAAA-TQZZA 549
7.10.11.12 receive
Table 589 receive command
7.10.11.13 send
Table 590 send command
Parameters preference — An integer.
Values: 1 — 255
Default: 100
Item Description
(2 of 2)
Item Description
Syntax receive receive-type
no receive
Context configure>service>vprn>rip
configure>service>vprn>rip>group
configure>service>vprn>rip>group>neighbor
Description This command configures the type(s) of RIP updates that will be accepted and processed.
If both or version-2 is specified, the RIP instance listens for and accepts packets sent to the
broadcast and multicast (224.0.0.9) addresses.
If version-1 is specified, the router only listens for and accepts packets sent to the broadcast
address.
This control can be issued at the global, group or interface level. The default behavior accepts
and processes both RIPv1 and RIPv2 messages.
The no form of the command resets the type of messages accepted to both.
Default no receive — Accepts both formats.
Parameters both — Receive RIP updates in either Version 1 or Version 2 format.
none — Do not accept and RIP updates.
version-1 — Router should only accept RIP updates in Version 1 format.
version-2 — Router should only accept RIP updates in Version 2 format.
Item Description
Syntax send send-type
no send
(1 of 2)