Nokia 7330 - BGP Commands; Table 498 Bgp Command; Table 499 Advertise-Inactive Command

FD 100/320Gbps NT and FX NT IHub Services Guide Virtual Private Routed Network Service
Issue: 13 3HH-11985-AAAA-TQZZA 499
7.10.9 BGP Commands
7.10.9.1 bgp
Table 498 bgp command
7.10.9.2 advertise-inactive
Table 499 advertise-inactive command
Description This command display information about a particular GRE tunnel or all GRE tunnels.
Count option displays the number of GRE tunnels in the system.
Parameters gre-tunnel-name — Specifies the name of a GRE tunnel.
Item Description
(2 of 2)
Item Description
Syntax [no] bgp
Context service>vprn
Description This command enables the BGP protocol with the VPRN service.
The no form of the command disables the BGP protocol from the given VPRN service.
Default no bgp
Item Description
Syntax [no] advertise-inactive
Context configure>service>vprn>bgp
configure>service>vprn>bgp>group
configure>service>vprn>bgp>group>neighbor
Description This command enables or disables the advertising of inactive BGP routers to other BGP peers.
By default, BGP only advertises BGP routes to other BGP peers if a given BGP route is chosen
by the route table manager as the most preferred route within the system and is active in the
forwarding plane. This command allows system administrators to advertise a BGP route even
though it is not the most preferred route within the system for a given destination.
Default no advertise-inactive