FD 100/320Gbps NT and FX NT IHub Services Guide Virtual Leased Line Services
Issue: 13 3HH-11985-AAAA-TQZZA 121
configure>service>epipe# shutdown
configure>service>epipe# exit
4.4.5.3 Re-enabling an Epipe Service
Use the following command to re-enable an Epipe service that was shut down:
configure>service> epipe service-id
no shutdown
Example:
configure>service# epipe 2
configure>service>epipe# no shutdown
configure>service>epipe# exit
4.4.5.4 Deleting an Epipe Service
Perform the following steps prior to deleting an Epipe service:
1 Shut down the SAP and SDP.
2 Delete the SAP and SDP.
3 Shut down the service.
Use the following CLI syntax to delete an Epipe service:
configure>service
[no] epipe service-id
shutdown
[no] sap sap-id
shutdown
[no] spoke-sdp sdp-id:vc-id
shutdown
Example:
configure>service# epipe 2
configure>service>epipe# sap lt:1/1/1:21
configure>service>epipe>sap# shutdown
configure>service>epipe>sap# exit
configure>service>epipe# no sap lt:1/1/1:21
configure>service>epipe# spoke-sdp 2:6000
configure>service>epipe>spoke-sdp# shutdown
configure>service>epipe>spoke-sdp# exit
configure>service>epipe# no spoke-sdp 2:6000
configure>service>epipe# epipe 2
configure>service>epipe# shutdown
configure>service>epipe# exit
configure>service# no epipe 2
To Next Page
Loading...
