Virtual Leased Line Services
152
FD 100/320Gbps NT and FX NT IHub Services Guide
3HH-11985-AAAA-TQZZA Issue: 13
4.6.6.9 labels
Table 99 labels command
Table 100 describes the command output fields.
Table 100 Show Service-ID Labels Output Fields
SAP Count The number of SAPs defined on the service.
SDP Bind Count SDP Bind Count
Identifier Specifies the service access (SAP) and destination (SDP) points.
Type Specifies the signaling protocol used to obtain the ingress and egress labels used in
frames transmitted and received on the SDP.
AdmMTU Specifies the desired largest service frame size (in octets) that can be transmitted
through this SDP to the far-end ESR, without requiring the packet to be fragmented.
OprMTU Specifies the actual largest service frame size (in octets) that can be transmitted through
this SDP to the far-end ESR, without requiring the packet to be fragmented.
Opr The operating state of the SDP.
Label Description
(2 of 2)
Item Description
Syntax labels
Context show>service>id
Description Displays the labels being used by the service.
Label Description
Svc Id The service identifier.
Sdp Id The SDP identifier.
Type Indicates whether the SDP is a spoke or a mesh.
I. Lbl The VC label used by the far-end device to send packets to this device in this service by
the SDP.
E. Lbl The VC label used by this device to send packets to the far-end device in this service by
the SDP.
To Next Page
Loading...
Need help?
General
