FD 100/320Gbps NT and FX NT IHub Services Guide Virtual Private LAN Service
Issue: 13 3HH-11985-AAAA-TQZZA 219
For example:
configure service vpls 1
configure service vpls 1 shutdown
configure>service>vpls1>exit
5.9.3 Deleting a VPLS Service or SAP
A VPLS service cannot be deleted until SAPs are unbound (deleted), interfaces are
shutdown, and the service is shutdown on the service level.
The following is an example of the CLI syntax to delete a VPLS service:
configure service no vpls <service-id>
The following is an example of the CLI syntax to delete a VPLS SAP:
configure service vpls <service-id> no sap {<port-id> | <lag-id>}:vlanid
The following is an example of the command output:
ALA-A>configure>service>vpls# info
----------------------------------------------
configure>service
no vpls service-id
shutdown
no sap service-id
description “SAP”
shutdown
----------------------------------------------
ALA-A>configure>service>vpls#
5.9.4 Showing VPLS information
You can view information about an m-VPLS or v-VPLS, including the following:
• FDB database and MAC forwarding information (not applicable for m-VPLS)
• all services
• base services
• fdb sap specific details
• services using m-VPLS
• services using v-VPLS
The show service command with one of the applicable parameters can be used to
view VPLS information:
show service id <service-id> {all | base | fdb | igmp-snooping | mfib |
mstp-configuration | sap | stp | service-using | sap-using}
The following example shows the information for a v-VPLS forwarding database:
To Next Page
Loading...
