Nokia 7330 - Far-End; Table 9 Adv-Mtu-Override Command; Table 10 Far-End Command

Services Overview
82
FD 100/320Gbps NT and FX NT IHub Services Guide
3HH-11985-AAAA-TQZZA Issue: 13
Table 9 adv-mtu-override command
3.17.3.3 far-end
Table 10 far-end command
Item Description
Syntax [no] adv-mtu-override
Context configure>service>sdp sdp-id
Description This command overrides the advertised VC-type MTU. When enabled, the ISAM signals a VC
MTU equal to the service MTU (includes the Layer 2 header). Under normal operations it will
advertise the service MTU minus the Layer 2 header. In the receive direction, it will accept
either one.
The no form of the command disables the VC-type MTU override.
Default no adv-mtu-override
Item Description
Syntax far-end ip-address
no far-end
Context configure>service>sdp sdp-id
Description This command configures the system IP address of the far-end destination ISAM router for the
Service Distribution Point (SDP) that is the termination point for a service.
The far-end IP address must be explicitly configured. The destination IP address must be a
ISAM system IP address.
The far-end ip-address is used to check LSP names when added to the SDP. If the “to IP
address” defined within the LSP configuration does not exactly match the SDP far-end
ip-address, the LSP will not be added to the SDP and an error will be generated.
An SDP cannot be administratively enabled until a far-end ip-address is defined. The SDP is
operational when it is administratively enabled (no shutdown) and the far-end ip-address is
contained in the IGP routing table as a host route. OSPF ABRs should not summarize host
routes between areas. This can cause SDPs to become operationally down. Static host routes
(direct and indirect) can be defined in the local ISAM to alleviate this issue.
The no form of this command removes the currently configured destination IP address for the
SDP. The ip-address parameter is not specified and will generate an error if used in the no
far-end command. The SDP must be administratively disabled using the configure service
sdp shutdown command before the no far-end command can be executed. Removing the
far-end IP address will cause all lsp-name associations with the SDP to be removed.
Default none
Parameters ip-address — The system address of the far-end ISAM for the SDP in dotted decimal notation.