FD 100/320Gbps NT and FX NT IHub Services Guide Virtual Private Routed Network Service
Issue: 13 3HH-11985-AAAA-TQZZA 451
7.10.2.3 autonomous-system
Table 413 autonomous-system command
Parameters summary-only — This optional parameter suppresses advertisement of more specific
component routes for the aggregate.
as-set — This optional parameter is only applicable to BGP and creates an aggregate where
the path advertised for this route will be an AS_SET consisting of all elements contained in all
paths that are being summarized.
aggregator — This optional parameter specifies the BGP aggregator path attribute to the
aggregate route. When configuring the aggregator, a two-octet AS number used to form the
aggregate route must be entered, followed by the IP address of the BGP system that created
the aggregate route.
ip-prefix/prefix-length - The destination address of the aggregate route.
Values: ipv4-prefix a.b.c.d (host bits must be 0)
ipv4-prefix-length 0 — 32
ipv6-prefix x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x: [0 — FFFF]H
d: [0 — 255]D
ipv6-prefix-length 0 — 64
as-number — The 16-bit AS number.
Values: 1 — 65535
ip-address — The IP address in dotted decimal notation.
Item Description
(2 of 2)
Item Description
Syntax autonomous-system as-number
no autonomous-system
Context configure>service>vprn
Description This command defines the autonomous system (AS) to be used by this VPN
routing/forwarding (VRF).
The no form of the command removes the defined AS from this VPRN context.
Default No autonomous system
Parameters as-number — The 16-bit AS number.
Values: 1 — 65535
To Next Page
Loading...
