Internet Enhanced Service
412
FD 100/320Gbps NT and FX NT IHub Services Guide
3HH-11985-AAAA-TQZZA Issue: 13
Table 399 describes the command output fields.
Table 399 Show service id Interface Output
Parameters ip-address — The IP address of the interface for which to display information.
Values: ipv4-address: a.b.c.d (host bits must be 0)
ip-int-name — Specifies the IP interface name for which to display information.
Values: 32 characters maximum
family — Displays the router IP interface table to display.
Values: ipv4 — Displays only those peers that have the IPv4 family enabled.
ipv6 — Displays the peers that are IPv6-capable.
interface-type — Specifies to display either group or subscriber interfaces.
Values: group, subscriber
detail — Displays detailed IP interface information.
Default: IP interface summary output.
Label Description
Interface-Name The name used to refer to the IES interface.
Type Specifies the interface type.
IP-Address Specifies the IP address/IP subnet/broadcast address of the interface.
Adm The administrative state of the interface.
Opr The operational state of the interface.
Interface
If Name The name used to refer to the interface.
Admin State The administrative state of the interface.
Oper State The operational state of the interface.
IP Addr/mask Specifies the IP address/IP subnet/broadcast address of the interface.
Details
If Index The index corresponding to this IES interface. The primary index is 1; all IES interfaces
are defined in the base virtual router context.
If Type Specifies the interface type.
Port Id Specifies the SAP port ID.
SNTP B.Cast Specifies whether SNTP broadcast client mode is enabled or disabled.
Arp Timeout Specifies the timeout for an ARP entry learned on the interface.
MAC Address Specifies the 48-bit IEEE 802.3 MAC address.
ICMP Mask Reply Specifies whether ICMP mask reply is enabled or disabled.
Cflowd Specifies whether Cflowd collection and analysis on the interface is enabled or disabled.
(1 of 2)
Item Description
(2 of 2)
To Next Page
Loading...
