FD 100/320Gbps NT and FX NT IHub Services Guide Virtual Private Routed Network Service
Issue: 13 3HH-11985-AAAA-TQZZA 521
7.10.9.40 type
Table 537 type command
7.10.10 OSPF Commands
7.10.10.1 ospf
Table 538 ospf command
Item Description
Syntax [no] type {internal | external}
Context configure>service>vprn>bgp>group
configure>service>vprn>bgp>group>neighbor
Description This command designates the BGP peer as type internal or external.
The type of internal indicates the peer is an IBGP peer while the type of external indicates that
the peer is an EBGP peer.
By default, the OS derives the type of neighbor based on the local AS specified. If the local AS
specified is the same as the AS of the router, the peer is considered internal. If the local AS is
different, then the peer is considered external.
The no form of the command used at the group level reverts to the default value.
The no form of the command used at the neighbor level reverts to the value defined at the
group level.
Default no type — Type of neighbor is derived on the local AS specified.
Parameters internal — Configures the peer as internal.
external — Configures the peer as external.
Item Description
Syntax [no] ospf
Context configure>service>vprn
Description This command enables access to the context to enable an OSPF protocol instance.
When an OSPF instance is created, the protocol is enabled. To start or suspend execution of
the OSPF protocol without affecting the configuration, use the no shutdown command.
The no form of the command deletes the OSPF protocol instance removing all associated
configuration parameters.
Default no ospf — The OSPF protocol is not enabled.
To Next Page
Loading...
Need help?
General
