FD 100/320Gbps NT and FX NT IHub Services Guide Virtual Private Routed Network Service
Issue: 13 3HH-11985-AAAA-TQZZA 527
7.10.10.11 interface-type
Table 548 interface-type command
7.10.10.12 message-digest-key
Table 549 message-digest-key command
Item Description
Syntax interface-type {broadcast | point-to-point}
no interface-type
Context configure>service>vprn>ospf>area>interface
Description This command configures the interface type to be either broadcast or point-to-point.
Use this command to set the interface type of an Ethernet link to point-to-point to avoid having
to carry the broadcast adjacency maintenance overhead if the Ethernet link provided the link
is used as a point-to-point.
If the interface type is not known at the time the interface is added to OSPF and subsequently
the IP interface is bound (or moved) to a different interface type, this command must be
entered manually.
The no form of the command reverts to the default value.
Default broadcast — If the physical interface is Ethernet or unknown.
Parameters broadcast — Configures the interface to maintain this link as a broadcast network. To
significantly improve adjacency forming and network convergence, a network should be
configured as point-to-point if only two routers are connected, even if the network is a
broadcast media such as Ethernet.
point-to-point — Configures the interface to maintain this link as a point-to-point link.
Item Description
Syntax message-digest-key keyid md5 [key | hash-key]
no message-digest-key keyid
Context configure>service>vprn>ospf>area>interface
Description This command configures a message digest key when MD5 authentication is enabled on the
interface. Multiple message digest keys can be configured.
The no form of the command removes the message digest key identified by the key-id.
Default no message-digest-key
(1 of 2)
To Next Page
Loading...
