FD 100/320Gbps NT and FX NT IHub Services Guide Internet Enhanced Service
Issue: 13 3HH-11985-AAAA-TQZZA 387
6.10.7.3 dhcp6-relay
Table 354 dhcp6-relay command
6.10.7.4 lease-query
Table 355 lease-query command
Parameters ipv6-address/prefix-length — Specifies the IPv6 address on the interface.
Values: ipv6-address/prefix: ipv6-address x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x [0 — FFFF]H
d [0 — 255]D
prefix-length 1 — 126
eui-64 — When the eui-64 keyword is specified, a complete IPv6 address from the supplied
prefix and 64-bit interface identifier is formed. The 64-bit interface identifier is derived from
MAC address on Ethernet interfaces. For interfaces without a MAC address, for example ATM
interfaces, the Base MAC address of the chassis is used.
Item Description
(2 of 2)
Item Description
Syntax [no] dhcp6-relay
Context configure>service>ies>interface>ipv6
Description This command configures DHCPv6 relay parameters for the IES interface.
Item Description
Syntax lease-query {enable | disable}]
no lease-query
Context configure>service>ies>interface>ipv6>dhcp6-relay
Description Enables lease-query functionality in this interface. If enabled, v6 lease query requests from LT
will be handled and processed.
Default The default value is Disabled.
Parameters {Enable} — Lease query received on the interface will be processed. Only bulk lease query is
supported. Bulk lease query based on remote ID will be supported.
{Disable} — Lease query functionality is disabled on this interface. Lease query packets
received on the interface will be dropped.
To Next Page
Loading...
Need help?
General
