Nokia 7330 - Table 437 Rate-Limit Command

FD 100/320Gbps NT and FX NT IHub Services Guide Virtual Private Routed Network Service
Issue: 13 3HH-11985-AAAA-TQZZA 463
7.10.2.27 rate-limit
Table 437 rate-limit command
Description The ingress QoS policy defines the match criteria used to determine what Forwarding Class
(FC) each packet is associated to. Associating a QoS policy to a VPRN service effectively
associates the QoS policy to all SAPs of a VPRN service at one time.
The ingress QoS policy is installed in the hardware when the first service is associated to it.
Similarly, when the last service is disassociated from it, the policy is removed from the
hardware (except for the default policy which cannot be deleted from hardware).
Only one QoS policy can be associated to a VPRN service.
Note that the VPRN service will be associated with one or more VPLS services. The ingress
QoS policy that is directly associated with the VPRN takes precedence of those associated
with the VPLS services.
The no form of this command associates the VPRN service to the default policy.
Default By default, each VPRN service is associated to QoS policy ID 1
Parameters policy-id — The ID of the QoS policy.
Values: 2 — 65535
Item Description
(2 of 2)
Item Description
Syntax rate-limit cir cir-rate pir pir-rate [cbs cbs-size] [pbs pbs-size]
no priority
Context configure>service>vprn>egress
Description This command defines the aggregate egress rate limit per VPRN service.
It applies to traffic associated to the VPRN service which is egressing on regular ports (network
ports)
The committed information rate and the peak information rate are entered
Optionally, the committed burst size and the peak burst size may be entered. If these values
are not specified, they assume the default value of 256 Mbytes.
The no form of this command removes rate limiting from a VPRN.
(1 of 2)