Nokia 7330 - RIP Commands; Table 578 Rip Command; Table 579 Authentication-Key Command

FD 100/320Gbps NT and FX NT IHub Services Guide Virtual Private Routed Network Service
Issue: 13 3HH-11985-AAAA-TQZZA 543
7.10.11 RIP Commands
7.10.11.1 rip
Table 578 rip command
7.10.11.2 authentication-key
Table 579 authentication-key command
Parameters max-spf-wait — Specifies the maximum interval in milliseconds between two consecutive SPF
calculations.
Values: 1 — 120000
Default: 1000
spf-initial-wait — Specifies the initial SPF calculation delay in milliseconds after a topology
change.
Values: 10 — 100000
Default: 1000
spf-second-wait — Specifies the hold time in milliseconds between the first and second SPF
calculation.
Values: 10 — 100000
Default: 1000
Item Description
(2 of 2)
Item Description
Syntax [no] rip
Context configure>service>vprn
Description This command enables the RIP protocol on the given VPRN IP interface.
The no form of the command disables the RIP protocol from the given VPRN IP interface.
Default no rip
Item Description
Syntax authentication-key [authentication-key | hash-key] [hash2]
no authentication-key
(1 of 2)