Internet Enhanced Service
370
FD 100/320Gbps NT and FX NT IHub Services Guide
3HH-11985-AAAA-TQZZA Issue: 13
6.10.3.2 ingress
Table 325 ingress command
6.10.3.3 qos
Table 326 qos command
Context configure>service>ies
Description This command enables the context to configure egress rate-limiting policies.
If no egress filter is defined, no rate-limiting is performed.
Item Description
(2 of 2)
Item Description
Syntax ingress
Context configure>service>ies
Description This command enables the context to configure ingress QoS policies.
Item Description
Syntax qos policy-id
no qos
Context configure>service>ies>ingress
Description The ingress QoS policy defines the match criteria used to determine what Forwarding Class
(FC) each packet is associated to. Associating a QoS policy to a IES service effectively
associates the QoS policy to all SAPs of a IES service at one time.
The ingress QoS policy is installed in the hardware when the first service is associated to it.
Similarly, when the last service is disassociated from it, the policy is removed from the
hardware (except for the default policy which cannot be deleted from hardware).
Only one QoS policy can be associated to a IES service.
Note that the IES service will be associated with one or more VPLS services. The ingress QoS
policy that is directly associated with the IES takes precedence of those associated with the
VPLS services.
The no form of this command associates the IES service to the default policy.
Default By default, each IES service is associated to QoS policy ID 1
Parameters policy-id — The ID of the QoS policy.
Values: 2 — 65535
To Next Page
Loading...
