Nokia 7330 - Table 273 Stp Command; Table 274 Show Service-ID STP Command Output Fields

FD 100/320Gbps NT and FX NT IHub Services Guide Virtual Private LAN Service
Issue: 13 3HH-11985-AAAA-TQZZA 331
5.16.7.11 stp
Table 273 stp command
Table 274 describes the command output fields.
Table 274 Show Service-ID STP Command Output Fields
Measure-time The amount of time, measured in seconds that statistics for this entry have been
actually counted for the 1-day interval. This value will be the same as the interval
except in a situation where performance monitoring data could not be collected for this
SAP for some reason
Label Description
(2 of 2)
Item Description
Syntax stp [detail]
stp mst-instance mst-inst-number
Context show>service>id
Description This command displays information for the spanning tree protocol instance for the service.
Parameters detail - Displays detailed information.
mst-inst-number - [1..4093]
Label Description
RSTP Admin State Indicates the administrative state of the Rapid Spanning Tree Protocol instance
associated with this service.
Core Connectivity Indicates the connectivity status to the core.
RSTP Oper State Indicates the operational state of the Rapid Spanning Tree Protocol instance
associated with this service. This field is applicable only when STP is enabled on the
router.
Bridge-id Specifies the MAC address used to identify this bridge in the network.
Hold Time Specifies the interval length during which no more than two Configuration BPDUs shall
be transmitted by this bridge.
Bridge fwd delay Specifies how fast a bridge changes its state when moving toward the forwarding state.
Bridge Hello time Specifies the amount of time between the transmission of Configuration BPDUs.
Bridge max age Specifies the maximum age of Spanning Tree Protocol information learned from the
network on any port before it is discarded. This is the actual value that this bridge is
currently using.
Bridge priority Defines the priority of the Spanning Tree Protocol instance associated with this service.
Topology change Specifies whether a topology change is currently in progress.
(1 of 2)