Nokia 7330 - Mhf-Creation; CCM-Interval; Table 21 Mhf-Creation Command; Table 22 CCM-Interval Command

FD 100/320Gbps NT and FX NT IHub Services Guide Services Overview
Issue: 13 3HH-11985-AAAA-TQZZA 89
3.17.4.5 mhf-creation
Table 21 mhf-creation command
3.17.4.6 ccm-interval
Table 22 ccm-interval command
Parameters bridge-id - Specifies the bridge ID for the domain association.
Values: 1...2147483647
Item Description
(2 of 2)
Item Description
Syntax mhf-creation {default | none | explicit}
no mhf-creation
Context configure>eth-cfm>domain>association>bridge-identifier
Description This command determines whether to allow automatic MIP creation for the MA
The no form of the command disables automatic MIP creation.
Parameters default: Specifies that MHFs can be created for this VID only on bridge ports through which
this VID can pass without the requirement for a MEP at some lower MA level.
none: Specifies that no MHFs can be created for this VID.
explicit: Specifies that MHFs can be created for this VID only on bridge ports through which
this VID can pass, and only if a MEP is created at some lower MA level. There must be at least
one lower level MEP provisioned on the same SAP or SDP.
Item Description
Syntax ccm-interval interval
no ccm-interval
Context configure>eth-cfm>domain>association
Description This command configures the CCM transmission interval for all MEPs in the association.
The no form of the command reverts the value to the default.
Default 10 seconds
(1 of 2)