Nokia 7330 - Table 418 Interface Command; Table 419 Current-Hop-Limit Command; Table 420 Managed-Configuration Command; Interface

FD 100/320Gbps NT and FX NT IHub Services Guide Virtual Private Routed Network Service
Issue: 13 3HH-11985-AAAA-TQZZA 455
7.10.2.8 interface
Table 418 interface command
7.10.2.9 current-hop-limit
Table 419 current-hop-limit command
7.10.2.10 managed-configuration
Table 420 managed-configuration command
Item Description
Syntax [no] interface ip-int-name
Context configure>service>vprn>router-advertisement
Description This command configures router advertisement properties on a specific interface. The
interface must already exist in the configure>router>interface context.
Default No interfaces are configured by default.
Parameter ip-int-name — Specify the interface name. If the string contains special characters (#, $,
spaces, etc.), the entire string must be enclosed within double quotes.
Item Description
Syntax current-hop-limit number
no current-hop-limit
Context configure>service>vprn>router-advertisement>interface
Description This command configures the current-hop-limit in the router advertisement messages. It
informs the nodes on the subnet about the hop-limit when originating IPv6 packets.
Default 64
Parameter number — Specifies the hop limit.
Values: 0 — 255. A value of zero means there is an unspecified number of hops.
Item Description
Syntax [no] managed-configuration
Context configure>service>vprn>router-advertisement>interface
(1 of 2)