Virtual Private Routed Network Service
528
FD 100/320Gbps NT and FX NT IHub Services Guide
3HH-11985-AAAA-TQZZA Issue: 13
7.10.10.13 metric
Table 550 metric command
7.10.10.14 mtu
Table 551 mtu command
Parameters keyid — The keyid is expressed as a decimal integer.
Values: 1 — 255
md5 key — The MD5 key. The key can be any alphanumeric string up to 16 characters in
length.
md5 hash-key — The MD5 hash key. The key can be any combination of ASCII characters up
to 32 characters in length (encrypted). If spaces are used in the string, enclose the entire string
in quotation marks (“ ”).
This is useful when a user must configure the parameter, but, for security purposes, the actual
unencrypted key value is not provided.
Item Description
(2 of 2)
Item Description
Syntax metric metric
no metric
Context configure>service>vprn>ospf>area>interface
Description This command configures an explicit route cost metric for the OSPF interface that overrides
the metrics calculated based on the speed of the underlying link.
The no form of the command deletes the manually configured interface metric, so the interface
uses the computed metric based on the reference-bandwidth command setting and the
speed of the underlying link.
Default no metric — The metric is based on reference-bandwidth setting and the link speed.
Parameters metric — The metric to be applied to the interface expressed as a decimal integer.
Values: 1 — 65535
Item Description
Syntax mtu bytes
no mtu
Context configure>service>vprn>ospf>area>interface
(1 of 2)
To Next Page
Loading...
Need help?
General
