Nokia 7330 - IES Qos Policy Commands; Table 324 Egress Command

FD 100/320Gbps NT and FX NT IHub Services Guide Internet Enhanced Service
Issue: 13 3HH-11985-AAAA-TQZZA 369
6.10.3 IES QoS Policy Commands
6.10.3.1 egress
Table 324 egress command
Context configure>service
Description This command creates or edits an IES service instance.
The ies command is used to create or maintain an Internet Enhanced Service (IES). If the
service-id does not exist, a context for the service is created. If the service-id exists, the context
for editing the service is entered.
IES services allow the creation of customer facing IP interfaces in the same routing instance
used for service network core routing connectivity. IES services require that the IP addressing
scheme used by the subscriber must be unique between it and other addressing schemes
used by the provider and potentially the entire Internet.
IP interfaces defined within the context of an IES service ID must have a SAP created as the
access point to the subscriber network. This allows a combination of bridging and IP routing
for redundancy purposes.
When a service is created, the customer keyword and customer-id must be specified and
associates the service with a customer. The customer-id must already exist having been
created using the customer command in the service context. Once a service has been created
with a customer association, it is not possible to edit the customer association. The service
must be deleted and recreated with a new customer association.
Once a service is created, the use of the customer customer-id is optional for navigating into
the service configuration context. Attempting to edit a service with the incorrect customer-id
specified will result in an error.
More than one IP interface may be created within a single IES service ID. All IP interfaces
created within an IES service ID belongs to the same customer.
By default, no IES service instances exist until they are explicitly created.
The no form of this command deletes the IES service instance with the specified service-id.
The service cannot be deleted until all the IP interfaces defined within the service ID have been
shutdown and deleted.
Parameters service-id — The unique service identification number identifying the service in the service
domain. This ID must be unique to this service and may not be used for any other service of
any type. The service-id must be the same number used for every ISAM on which this service
is defined.
Values: 1 — 2147483648
customer customer-id — Specifies the customer ID number to be associated with the service.
This parameter is required on service creation and optional for service editing or deleting.
Values: 1 — 2147483647
Item Description
(2 of 2)
Item Description
Syntax egress
(1 of 2)