Nokia 7330 - Multihop; Table 528 Multihop Command; Table 529 Multipath Command

Virtual Private Routed Network Service
516
FD 100/320Gbps NT and FX NT IHub Services Guide
3HH-11985-AAAA-TQZZA Issue: 13
7.10.9.31 multihop
Table 528 multihop command
7.10.9.32 multipath
Table 529 multipath command
Parameters seconds — The minimum route advertising interval, in seconds, expressed as a decimal
integer.
Values: 1 — 255
Item Description
(2 of 2)
Item Description
Syntax multihop ttl-value
no multihop
Context configure>service>vprn>bgp
configure>service>vprn>bgp>group
configure>service>vprn>bgp>group>neighbor
Description This command configures the time to live (TTL) value entered in the IP header of packets sent
to an EBGP peer multiple hops away.
This parameter is meaningful only when configuring EBGP peers. It is ignored if set for an
IBGP peer.
The no form of the command is used to convey to the BGP instance that the EBGP peers are
directly connected.
The no form of the command reverts to default values.
Default 1 — EBGP peers are directly connected.
64 — IBGP
Parameters ttl-value — The TTL value, expressed as a decimal integer.
Values: 1 — 255
Item Description
Syntax multipath max-paths
no multipath
Context configure>service>vprn>bgp
(1 of 2)