Virtual Private LAN Service
316
FD 100/320Gbps NT and FX NT IHub Services Guide
3HH-11985-AAAA-TQZZA Issue: 13
5.16.6.12 group
Table 246 group command
5.16.6.13 source
Table 247 source command
Item Description
Syntax group grp-ip-address
[no] group
Context configure>service>vpls>igmp-snooping>static
configure>service>vpls>sap>igmp-snooping>static
configure>service>mesh-sdp>igmp-snooping>static
configure>service>spoke-sdp>igmp-snooping>static
Description This command adds a static multicast group either as a (*,G) or one or more (S,G) records.
Use IGMP static group memberships to test multicast forwarding without a receiver host. When
IGMP static groups are enabled, data is forwarded to an interface without receiving
membership reports from host members.
In case of VPLS context, data will be forwarded to all interfaces of the given service.
Default None
Parameters grp-ip-address — Specifies an IGMP multicast group address that receives data on an
interface. The IP address must be unique for each static group. Specify the address in dotted
decimal notation.
Item Description
Syntax source ip-address
[no] source
Context configure>service>vpls>igmp-snooping>static>group
configure>service>vpls>sap>igmp-snooping>static>group
configure>service>mesh-sdp>igmp-snooping>static>group
configure>service>spoke-sdp>igmp-snooping>static>group
Description This command specifies a IPv4 unicast address that sends data on an interface. This enables
a multicast receiver host to signal a router the group is to receive multicast traffic from, and
from the source(s) that the traffic is expected.
The source command is mutually exclusive with the specification of individual sources for the
same group.
The source command in combination with the group is used to create a specific (S,G) static
group entry.
In case of VPLS context, the data will be forwarded to all interfaces of the given service.
Use the no form of the command to remove the source from the configuration.
Default None
(1 of 2)
To Next Page
Loading...
