Services Overview
86
FD 100/320Gbps NT and FX NT IHub Services Guide
3HH-11985-AAAA-TQZZA Issue: 13
3.17.3.9 vlan-vc-etype
Table 16 vlan-vc-etype command
3.17.4 Ethernet CFM Global Commands
3.17.4.1 eth-cfm
Special Cases Service Admin State - Bindings to an SDP within the service will be put into the out-of-service
state when the service is shutdown. While the service is shutdown, all customer packets are
dropped and counted as discards for billing and debugging purposes.
SDP (global) - When an SDP is shutdown at the global service level, all bindings to that SDP
are put into the out-of-service state and the SDP itself is put into the administratively and
operationally down states. Packets that would normally be transmitted using this SDP binding
will be discarded and counted as dropped packets.
SDP (service level) - Shutting down an SDP within a service only affects traffic on that service
from entering or being received from the SDP. The SDP itself may still be operationally up for
other services.
Item Description
(2 of 2)
Item Description
Syntax vlan-vc-etype etype
no vlan-vc-etype
Context configure>service>sdp
Description This command enables the configuration of an alternate TPID value to be used at the SDP
level.
The no form of this command disables the configuration of an alternate TPID value..
Default no vlan-vc-etype
Parameters etype - specifies the etype value
Values are:
• hexadecimal: 0x0600 to 0xffff
• decimal: 1536 to 65535
To Next Page
Loading...
