Nokia 7330 - Configuring VPLS Components

FD 100/320Gbps NT and FX NT IHub Services Guide Virtual Private LAN Service
Issue: 13 3HH-11985-AAAA-TQZZA 189
4 Define mesh/spoke SDP's for the VPLS (optional)
• Associate the service to an existing SDP
5 Modify STP default parameters for the m-VPLS (optional).
6 Modify v-VPLS parameters such as user-to-user communication, mac learning
and aging, FDB database size (optional).
7 Modify IGMP snooping parameters for the v-VPLS instances and the VPLS
instances (optional).
8 Enable the service.
5.8 Configuring VPLS Components
This section describes how to configure v-VPLS and m-VPLS entities, including CLI
command syntax and examples. For complete command and parameter
descriptions see also the sections “VPLS Service CLI Command
Reference”and “VPLS Service CLI Configuration Commands”.
This section provides information about configuring the following entities:
• Creating a VPLS Service
• Configuring Spanning Tree Protocols on m-VPLS
• Configuring v-VPLS/VPLS parameters
• Configuring VPLS SAPs
• Configuring VPLS SAP Parameters
• Configuring SAP-Specific STP Parameters
• Configuring SDP Bindings
5.8.1 Creating a VPLS Service
Only one m-VPLS service is configured per ISAM, using the default customer ID 1.
Note that in the CLI syntax example, customer ID must be specified when creating
the service, but is optional when modifying an existing service.
configure service vpls <service-id> customer {1 | <customer-id>} {m-vpls - |
v-vpls <vlan-id>}
The following is an example of a basic m-VPLS configuration. Note that the
description can only be added and the admin state changed to up using the [no]
shutdown command, after the service is created.
*A:ALA-1>configure>service>vpls# info
----------------------------------------------
...
m-vpls 1 customer 1 create
description “Local mVPLS”
stp
shutdown