Nokia 7330 - Route-Distinguisher; Table 433 Route-Distinguisher Command; Table 434 Router-ID Command

FD 100/320Gbps NT and FX NT IHub Services Guide Virtual Private Routed Network Service
Issue: 13 3HH-11985-AAAA-TQZZA 461
7.10.2.23 route-distinguisher
Table 433 route-distinguisher command
7.10.2.24 router-id
Table 434 router-id command
Parameter seconds — The length of time, in seconds, (relative to the time the packet is sent) that the
prefix is valid for route determination.
Values: 0, 4 — 9000 seconds. 0 means that the router is not a default router on this link.
Item Description
(2 of 2)
Item Description
Syntax route-distinguisher [ip-address:number | asn:number]
no route-distinguisher
Context configure>service>vprn
Description This command sets the identifier attached to routes the VPN belongs to. Each routing instance
must have a unique (within the carrier’s domain) route distinguisher associated with it. A route
distinguisher must be defined for a VPRN to be operationally active.
Default No route-distinguisher
Parameters ip-address:number — Specify the IP address in dotted decimal notation. The assigned number
must not be greater than 65535.
asn:number — The ASN is a 2-byte value less than or equal to 65535. The assigned number
can be any 32-bit unsigned integer value.
Item Description
Syntax router-id ip-address
no router-id
Context configure>service>vprn
configure>service>vprn>ospf
configure>service>vprn>bgp
(1 of 2)