Virtual Private LAN Service
256
FD 100/320Gbps NT and FX NT IHub Services Guide
3HH-11985-AAAA-TQZZA Issue: 13
5.16.2.9 static-mac
Table 132 static-mac command
5.16.2.10 suppress-standby-signaling
Table 133 suppress-standby-signaling command
Parameters revert-time — [0..600 seconds]
infinite — makes endpoint non-revertive
Item Description
(2 of 2)
Item Description
Syntax static-mac ieee-address [create]
no static-mac
Context configure>service>vpls>endpoint
Description This command assigns a static-mac to the endpoint. In FDB, the static-mac is then associated
with the active spoke SDP.
Default None
Parameters ieee-address — 6-byte mac-address (xx:xx:xx:xx:xx:xx or xx-xx-xx-xx-xx-xx). Cannot be all
zeros.
Item Description
Syntax [no] suppress-standby-signaling
Context configure>service>vpls>endpoint
Description When this command is enabled, the pseudowire standby bit (value 0x00000020) will not be
sent to TLDP peer when the given spoke is selected as a standby. This allows faster
switchover as the traffic will be sent over this SDP and discarded at the blocking side of the
connection. This is particularly applicable to multicast traffic.
Default Enabled
To Next Page
Loading...
Need help?
General
