Nokia 7330 - Configuring a VPRN Interface - SAP

Virtual Private Routed Network Service
434
FD 100/320Gbps NT and FX NT IHub Services Guide
3HH-11985-AAAA-TQZZA Issue: 13
static-route 6.5.0.0/24 next-hop 10.1.1.2
no shutdown
exit
...
----------------------------------------------
*A:ALA-1>configure>service#
7.7.8 Configuring a VPRN Interface - SAP
To associate an IP interface to one or more network ports and/or access/hybrid ports,
at least two v-VPLS must be configured, one with a SAP on each associated
network/hybrid port, and one with the access/hybrid ports.
After creating the IP interface, an SAP must be created on the Virtual Port P1 for this
IP interface. Such an SAP is called “L3 SAP”.
The VLAN ID of the L3 SAP must be equal to the VLAN ID of the v-VPLS.
CLI syntax:
configure service vprn service-id interface ip-int-name sap [sap-id]
Filter policies are configured in the configure>filter context and must be explicitly
applied to a SAP. There are no default filter policies.
Refer to “Interface SAP Commands” for CLI commands and syntax.
For more information on the configuration of filters, see the “FD 100/320Gbps NT and
FX NT IHub Router Configuration and Protocols Guide”, chapter “Filter Policies”.
7.8 Service Management Tasks
This section discusses the following service management tasks:
7.8.1 Modifying VPRN Service Parameters
Use the CLI syntax to modify VPRN parameters (see “VPRN Services CLI Command
Reference”).
The following example displays the VPRN service creation output:
*A:ALA-1>configure>service# info
----------------------------------------------
...
vprn 1 customer 1 create
shutdown
vrf-import "vrfImpPolCust1"
vrf-export "vrfExpPolCust1"
ecmp 2