Virtual Private Routed Network Service
524
FD 100/320Gbps NT and FX NT IHub Services Guide
3HH-11985-AAAA-TQZZA Issue: 13
 
7.10.10.6 advertise-subnet
Table 543 advertise-subnet command
7.10.10.7 authentication-key
Table 544 authentication-key command
Description This command creates a context to configure an OSPF interface. 
By default interfaces are not activated in any interior gateway protocol such as OSPF unless 
explicitly configured. 
The no form of the command deletes the OSPF interface configuration for this interface. The 
shutdown command in the configure>router>ospf>interface context can be used to disable an 
interface without removing the configuration for the interface.
Default no interface — No OSPF interfaces are defined.
Parameters ip-int-name — The IP interface name. Interface names must be unique within the group of 
defined IP interfaces for configure router interface and configure service vprn interface 
commands. An interface name cannot be in the form of an IP address. Interface names can be 
any string up to 32 characters long composed of printable, 7-bit ASCII characters. If the string 
contains special characters (#, $, spaces, etc.), the entire string must be enclosed within 
double quotes.
If the IP interface name does not exist or does not have an IP address configured, an error 
message will be returned.
If the IP interface exists in a different area, it will be moved to this area.
Item Description
(2 of 2)
Item Description
Syntax [no] advertise-subnet
Context configure>service>vprn>ospf>area>interface
Description This command enables advertising point-to-point interfaces as subnet routes (network number 
and mask). When disabled, point-to-point interfaces are advertised as host routes.
The no form of the command disables advertising point-to-point interfaces as subnet routes 
meaning they are advertised as host routes. 
Default advertise-subnet — Advertises point-to-point interfaces as subnet routes.
Item Description
Syntax authentication-key [authentication-key | hash-key] [hash2]
no authentication-key
Context configure>service>vprn>ospf>area>interface
(1 of 2)