FD 100/320Gbps NT and FX NT IHub Services Guide Services Overview
Issue: 13 3HH-11985-AAAA-TQZZA 53
3.6.1 Phase 1: Core Network Construction
Before the services are provisioned, the following tasks should be completed:
• Build the IP or IP/MPLs core network.
• Configure routing protocols.
• Configure MPLS LSPs (if MPLS is used).
• Construct the core SDP service tunnel mesh for the services.
3.6.2 Phase 2: Service Administration
Perform preliminary policy configurations and SDP configurations to control traffic
flow, operator access, and to manage fault conditions and alarm messages.
3.6.3 Phase 3: Service Provisioning
• Provision customer account information.
• Provision the customer services on the ISAM by defining SAPs, and then by
binding the service to appropriate SDPs as necessary.
3.7 Configuration Notes
This section describes service configuration caveats.
3.7.1 General
Service provisioning tasks can be logically separated into two main functional areas,
core tasks and subscriber tasks and are typically performed prior to provisioning a
subscriber service.
Core tasks include the following:
• Create customer accounts
• Create LSPs
• Create SDPs
Subscriber services tasks include the following:
• Create Epipe, VLL, IES, VPLS, or VPRN services
• Configure interfaces (where required) and SAPs
• Bind SDPs
To Next Page
Loading...
