Virtual Leased Line Services
132
FD 100/320Gbps NT and FX NT IHub Services Guide
3HH-11985-AAAA-TQZZA Issue: 13
4.6.4.7 qos
Table 65 qos command
Parameters policy-id — The access QoS policy ID to associate with the service on ingress. The policy ID
must already exist.
Values: 1 — 65535
Item Description
(2 of 2)
Item Description
Syntax qos policy-id
no qos
Context configure>service>epipe>egress-network
configure>service>epipe>ingress-network
Description This command associates a Quality of Service (QoS) network policy with the service.
QoS ingress and egress policies are important for the enforcement of SLA agreements. A
network Policy can be associated to the service for ingress, respectively egress side.
A Service Egress network QoS Policy defines the match criteria used to determine the
mapping of Flow Class and profile indication towards the setting of the Experimental bits in
both labels (transport & VC) of the Pseudo-Wire. A Service Ingress network QoS Policy defines
the match criteria used to determine what Flow Class each packet, entering via an SDP
Binding (i.e. Pseudo-Wire), is associated to.
The policy ID must be defined prior to associating the policy with the service. If the policy-id
does not exist, an error will be returned.
The qos command allows egress and ingress network policies to be associated to the
services. Attempts to associate a QoS policy of the wrong type returns an error.
Only one ingress QoS policy and one egress can be associated at one time. Attempts to
associate a second QoS policy of a given type will return an error.
By default, no specific QoS policies are associated so the default QoS policy is used.
The no form of this command removes the QoS policy association from the service, and the
QoS policy reverts to the default: policy ID 1.
Parameters policy-id — The network QoS policy ID to associate with the service on ingress, respectively
egress. The policy ID must already exist.
Values: 1 — 65535
To Next Page
Loading...
