Nokia 7330 - Group; Table 592 Group Command; Table 593 Neighbor Command

FD 100/320Gbps NT and FX NT IHub Services Guide Virtual Private Routed Network Service
Issue: 13 3HH-11985-AAAA-TQZZA 551
7.10.11.15 group
Table 592 group command
7.10.11.16 neighbor
Table 593 neighbor command
Parameters update — The RIP update timer value in seconds.
Values: 1 — 600
Default: 30
timeout — The RIP timeout timer value in seconds.
Values: 1 — 1200
Default: 180
flush — The RIP flush timer value in seconds.
Values: 1 — 1200
Default: 120
Item Description
(2 of 2)
Item Description
Syntax [no] group group-name
Context configure>service>vprn>rip
Description This command creates a context for configuring a RIP group of neighbors. RIP groups are a
way of logically associating RIP neighbor interfaces to facilitate a common configuration for RIP
interfaces.
The no form of the command deletes the RIP neighbor interface group. Deleting the group will
also remove the RIP configuration of all the neighbor interfaces currently assigned to this
group.
Default no group — No group of RIP neighbor interfaces defined
Parameters group-name — The RIP group name. Allowed values are any string up to 32 characters long
composed of printable, 7-bit ASCII characters. If the string contains special characters (#, $,
spaces, etc.), the entire string must be enclosed within double quotes.
Item Description
Syntax [no] neighbor ip-int-name
Context configure>service>vprn>rip>group
(1 of 2)