Virtual Leased Line Services
142
FD 100/320Gbps NT and FX NT IHub Services Guide
3HH-11985-AAAA-TQZZA Issue: 13
4.6.6 Show Commands
4.6.6.1 egress-label
Table 84 egress-label command
Table 85 describes the command output fields.
Table 85 Show Service Egress Label Output Fields
Item Description
Syntax egress-label start-label [end-label]
Context show>service
Description This command displays services using the range of egress labels. If only the mandatory
start-label parameter is specified, only services using the specified label are displayed.
If both start-label and end-label parameters are specified, the services using the range of labels
X where start-label <= X <= end-label are displayed.
Use the show router ldp bindings command to display dynamic labels.
Parameters start-label — The starting egress label value for which to display services using the label range.
If only start-label is specified, services only using start-label are displayed.
Values: 0, 2049 — 131071
end-label — The ending egress label value for which to display services using the label range.
Default: the start-label value
Values: 2049 — 131071
Label Description
Svc Id The ID that identifies a service.
Sdp Id The ID that identifies an SDP.
Type Indicates whether the SDP binding is a spoke or a mesh.
I. Lbl The VC label used by the far-end device to send packets to this device in this service by
the SDP.
E. Lbl The VC label used by this device to send packets to the far-end device in this service by
the SDP.
Number of bindings
found
The total number of SDP bindings that exist within the specified egress label range.
To Next Page
Loading...
