FD 100/320Gbps NT and FX NT IHub Services Guide Virtual Private Routed Network Service
Issue: 13 3HH-11985-AAAA-TQZZA 511
7.10.9.25 local-as
Table 522 local-as command
Description Configures the local IPv4 or IPv6 address used by the group or neighbor when communicating
with BGP peers.
Outgoing connections use the local-address as the source of the TCP connection when
initiating connections with a peer.
When a local address is not specified, the ISAM uses the system IP address when
communicating with IBGP peers and uses the interface address for directly connected EBGP
peers. This command is used at the neighbor level to revert to the value defined under the
group level.
The no form of the command removes the configured local-address for BGP.
The no form of the command used at the group level reverts to the value defined at the global
level.
The no form of the command used at the neighbor level reverts to the value defined at the
group level.
Default no local-address — The router ID is used when communicating with IBGP peers and the
interface address is used for directly connected EBGP peers.
Parameters ip-address — The local address expressed in dotted decimal notation. Allowed values are a
valid routable IPv4 or IPv6 address on the router, either an interface or system IP address.
Item Description
(2 of 2)
Item Description
Syntax local-as as-number [private]
no local-as
Context configure>service>vprn>bgp
configure>service>vprn>bgp>group
configure>service>vprn>bgp>group>neighbor
(1 of 2)
To Next Page
Loading...
Need help?
General
