FD 100/320Gbps NT and FX NT IHub Services Guide Virtual Private Routed Network Service
Issue: 13 3HH-11985-AAAA-TQZZA 485
7.10.6.7 remote-id
Table 471 remote-id command
7.10.6.8 prefix-stability
Table 472 prefix-stability command
Description The operator can configure the interface ID option. When the interface ID option is enabled all
the relay-forward messages will include interface-id option. The DHCPv6 server copies this
option to the relay-reply message. The ISAM uses this interface ID option in the relay-reply to
identify the link to which client the message needs to be forwarded.
Default no option
Parameters ascii-tuple — Specifies that the ASCII-encoded concatenated tuple will be used which
consists of the access-node-identifier, service-id, and interface-name, separated by “|”.
ifindex — Specifies that the interface index will be used. The interface index of a router
interface can be displayed using the command show>router>interface>detail.
sap-id — Specifies that the SAP ID will be used.
string <string> — Specifies that a string will be used. The string can be maximum 80
characters long.
Item Description
(2 of 2)
Item Description
Syntax [no] remote-id
Context configure>service>vprn>interface>ipv6>dhcp6-relay>option
Description If this option is configured, it will be added in all the relay-forward messages sent to the server.
This option provides information that will be used by the DHCPv6 server in decision making
about addresses, prefix delegation and configuration parameters that the client is to receive.
Default no remote-id
Item Description
Syntax prefix-stability {enable | disable}
no prefix-stability
Context configure>service>vprn>interface>dhcp6-relay
Description Enables prefix-stability functionality in the interface.
Default The default value is disabled.
(1 of 2)
To Next Page
Loading...
