FD 100/320Gbps NT and FX NT IHub Services Guide Services Overview
Issue: 13 3HH-11985-AAAA-TQZZA 97
3.17.5.7 path
Table 39 path command
3.17.5.8 control-mep
Table 40 control-mep command
3.17.6 Show Commands
Item Description
Syntax path {a|b} port-id raps-tag qtag|qinqtag
Context configure>eth-ring
Description This command configures one of the two paths supported under the Ethernet ring.
The no form of this command removes the path from under the Ethernet ring.
Note: The associated SAP need to be un-configured before the path can be deleted.
Parameters port-id - Specifies the physical port /lag for the path.
raps-tag ) Specifies the VLAN-ID to be used for Ethernet CFM and G.8031 control plane
exchanges.
The Q-in-Q RAPS-Tag is allowed on port with Qtag Encapsulation in case of iHUB.
The range of Q-in-Q Inner-Tag is [0…4093], a value of 0 Inner-Tag in turn acts as an Qtag. i.e,
RAPS and CCM Packets will be sent with Single Outer Tag.
Item Description
Syntax path {a|b} port-id raps-tag qtag
Context configure>eth-ring>path>eth-cfm>mep
Description This command enables the usage of the CC state by the Ethernet ring manager for
consideration in the protection algorithm. The use of the control-mep command is
recommended if fast failure detection is required, especially when Link Layer OAM does not
provide the required detection time.
The no form of this command disables the use of the CC state by the Ethernet ring manager
To Next Page
Loading...
