Nokia 7330 - Enabling Statistics Collection and PM Collection on an SAP

Virtual Private LAN Service
212
FD 100/320Gbps NT and FX NT IHub Services Guide
3HH-11985-AAAA-TQZZA Issue: 13
5.8.5.7 Enabling Statistics collection and PM collection on
an SAP
Statistics collection and PM collection are enabled on an SAP when “enable-stats” is
configured on that SAP.
The operator can then monitor ingress packets/octets and egress packets/octets on
an SAP.
32 15-minute interval and two 1-day interval instances will be collected and wrap
around after that.
The following example displays the enable-stats configuration:
*A:ALA-Dut-B>configure>service>vpls # info
----------------------------------------------
description "VPLS service 2100"
sap lt:1/1/1:5 create
description "Sap description for service id 2100"
enable-stats
exit
no shutdown
----------------------------------------------
*A:ALA-Dut-B>configure>service>vpls#
To disable enable-stats, use the no enable-stats command.
*A:ALA-Dut-B>configure>service>vpls# info
----------------------------------------------
description "VPLS service 2100"
sap lt:1/1/1:5 create
description "Sap description for service id 2100"
no enable-stats
exit
no shutdown
----------------------------------------------
*A:ALA-Dut-B>configure>service>vpls#
5.8.6 STP SAP Operational States
The operational state of STP within an SAP controls how BPDUs are transmitted and
handled when received. Defined states are:
• Operationally Disabled
• Operationally Discarding
• Operationally Learning
• Operationally Forwarding