Virtual Private Routed Network Service
464
FD 100/320Gbps NT and FX NT IHub Services Guide
3HH-11985-AAAA-TQZZA Issue: 13
7.10.2.28 rate-limit
Table 438 rate-limit command
Parameters cir cir-rate — The committed information rate expressed in kbps.
Values: up to 100 Gbps
pir pir-rate — The peak information rate expressed in kbps.
Values: up to 100 Gbps
cbs cbs-size — The committed burst size expressed in kBytes.
Default: 256 Mbytes
Values: up to 256 Mbytes
pbs pbs-size — The peak burst size expressed in kBytes.
Default: 256 Mbytes
Values: up to 256 Mbytes
Item Description
(2 of 2)
Item Description
Syntax rate-limit cir cir-rate pir pir-rate [cbs cbs-size] [pbs pbs-size]
no rate-limit
Context configure>service>ies>ingress
Description This command defines the aggregate ingress rate limit per VPLS service.
It applies to traffic associated to the VPLS service which is ingressing on regular ports (network
ports)
The committed information rate and the peak information rate are entered
Optionally, the committed burst size and the peak burst size may be entered. If these values
are not specified, they assume the default value of 256 Mbytes.
The no form of this command removes rate limiting from a VPLS.
Parameters cir cir-rate — The committed information rate expressed in kbps.
Values: up to 100 Gbps
pir pir-rate — The peak information rate expressed in kbps.
Values: up to 100 Gbps
cbs cbs-size — The committed burst size expressed in kBytes.
Default: 256 Mbytes
Values: up to 256 Mbytes
pbs pbs-size — The peak burst size expressed in kBytes.
Default: 256 Mbytes
Values: up to 256 Mbytes
To Next Page
Loading...
