Nokia 7330 - Ipv6 Commands; Table 352 Ipv6 Command; Table 353 Address Command

Internet Enhanced Service
386
FD 100/320Gbps NT and FX NT IHub Services Guide
3HH-11985-AAAA-TQZZA Issue: 13
6.10.7 IPv6 Commands
6.10.7.1 ipv6
Table 352 ipv6 command
6.10.7.2 address (ipv6)
Table 353 address command
Item Description
Syntax [no] ipv6
Context configure>service>ies>interface
Description This command configures an IPv6 interface.
Note — When IPv6 routing is configured on the IHub and an
iBridge is configured on the LT board, it is not possible to obtain
a DHCPv6 lease when IPv6 multicast control is disabled on the
LT board. This is due to the fact that the NT board requires
adding the <IPv6, MAC> information in the Neighbor Cache by
sending a downstream multicast Neighbor Solicitation
message. If IPv6 multicast control is disabled on the LT board,
such messages are discarded and the DHCPv6 connection
cannot be established. To allow IPv6 routing to work correctly,
IPv6 multicast control needs to be allowed on the LT board.
See the CLI Command Guide for FD 100/320Gbps NT and FX
NT for more information
Item Description
Syntax address ipv6-address/prefix-length [eui-64]
no address ipv6-address/prefix-length
Context configure>service>ies>interface>ipv6
Description This command assigns an IPv6 address to the IES interface.
Up to 254 global IPv6 addresses can be configured.
Note: The ISAM supports configuration of IPv6 interfaces with a prefix length up to /126. The
ISAM does not support /127 addresses.
(1 of 2)