Nokia 7330 - Table 405 Stp Command

FD 100/320Gbps NT and FX NT IHub Services Guide Internet Enhanced Service
Issue: 13 3HH-11985-AAAA-TQZZA 417
6.10.10.4 stp
Table 405 stp command
Description This command clears FDB entries for the service.
Parameters all — Clears all FDB entries.
mac ieee-address — Clears only FDB entries in the FDB table with the specified 48-bit MAC
address. The MAC address can be expressed in the form aa:bb:cc:dd:ee:ff or
aa-bb-cc-dd-ee-ff where aa, bb, cc, dd, ee and ff are hexadecimal numbers.
sap sap-id — Specifies the physical port identifier portion of the SAP definition.
Values: [port-id | lag-id] vlanid | no-tag
• port-id
Specifies the physical port ID in the following format:
<port-id> : <nwport-id | ltport-id>
nwport-id - <slot-address>:<port-type>:<port-num>
— slot-address - nt|nt-a|nt-b|ntio-1
— port-type - sfp | xfp |vp | eth | ieee1588 | AI
— port-num - port-number
ltport-id - lt:<rack>/<shelf>/<slot>
— lt - keyword
— rack - number identifying the rack
— shelf - number identifying the shelf
— slot - number identifying the slot
• lag-id
lag: keyword
id: 1 — 64
• vlanid
Specifies the VLAN ID to be associated with the port identified by the SAP. For v-VPLS,
the SAP VLAN ID must match the VLAN ID defined at the v-VPLS level. The null value can
also be specified, to indicate that the SAP will send and receive untagged frames. If this
SAP is not defined, untagged frames will be dropped.
The m-VPLS VLAN ID is always specified as no-tag, which is reserved for untagged L2CP
frames processed to be by the m-VPLS.
Values:
m-VPLS vlanid: no-tag
v-VPLS vlanid: 0 | 1— 4093 (0 specifies untagged frames)
• no-tag
Item Description
(2 of 2)
Item Description
Syntax stp
Context clear>service>statistics>id
Description Clears all spanning tree statistics for the service ID.