Rohde & Schwarz R&S SMW200A - Page 1047

Remote Control Commands
R&S
®
SMW200A
1047User Manual 1175.6632.02 ─ 30
[:SOURce<hw>]:BB:ARBitrary:MCARrier:CARRier<ch>:FILE........................................... 1054
[:SOURce<hw>]:BB:ARBitrary:MCARrier:CARRier<ch>:CONFlict?................................... 1054
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:STATe........................................ 1054
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:STARt........................................1055
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:STOP........................................ 1055
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:POWer:STEP............................. 1055
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:POWer[:STARt]...........................1055
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:PHASe:STEP............................. 1056
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:PHASe[:STARt]...........................1056
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:DELay:STEP.............................. 1056
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:DELay[:STARt]............................1057
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:FILE.......................................... 1057
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:EXECute....................................1057
[:SOURce<hw>]:BB:ARBitrary:MCARrier:PRESet
Sets all the multi-carrier parameters to their default values.
Example:
SOURce1:BB:ARBitrary:MCARrier:PRESet
Usage: Event
Manual operation: See "Set to Default" on page 386
[:SOURce<hw>]:BB:ARBitrary:MCARrier:SETTing:CATalog?
Queries the available settings files in the specified default directory. Only files with the
file extension *.arb_multcarr are listed.
Return values:
<Catalog> string
Example: See Example "Generating a multi carrier signal" on page 1026
Usage: Query only
Manual operation: See "Save/Recall Frame" on page 386
[:SOURce<hw>]:BB:ARBitrary:MCARrier:SETTing:LOAD <Filename>
Loads the selected file from the default or the specified directory. Loaded are files with
extension *.arb_multcarr.
Setting parameters:
<Filename> "<filename>"
Filename or complete file path; file extension can be omitted
Example: See Example "Generating a multi carrier signal" on page 1026.
Usage: Setting only
Manual operation: See "Save/Recall Frame" on page 386
SOURce Subsystem