Troubleshooting and Error Messages
R&S
®
SMW200A
1263User Manual 1175.6632.02 ─ 30
15.7.1 Hardware Configuration Settings
Access:
► Select "System Config > Setup > Instrument Assembly > Hardware Config".
The "Hardware Config" dialog lists all installed assemblies and externally connec-
ted instruments with information on their part and serial numbers, and revision
states. The BIOS version is also listed; firmware updates do not update the BIOS
version.
The dialog is divided in tabs, according to the hardware components of the signal
domains. The "Counter" tab provides information on the operation time and number
of times the instrument was powered on.
The remote commands required to query the hardware configuration are described in
Chapter 14.10, "DIAGnostic Subsystem", on page 868.
Assembly
The tables in the tabs show characteristics of the installed assemblies.
Connected external instruments are also shown.
"Path"
Shows the path to that the assembly belongs.
"Assembly"
Assembly designation.
"Part Number"
Part number of the assembly.
"Serial Number"
Serial number of the assembly.
"Revision"
Revision state of the assembly.
"Slot"
Indicates whether the assembly is connected to the serial bus or PCI
bus.
Remote command:
:DIAGnostic<hw>:BGINfo? on page 869
Counter
Displays information on the operation times of the R&S SMW.
Requesting Instrument Configuration and Specifications
To Next Page
Loading...