Troubleshooting and Error Messages
R&S
®
SMW200A
1264User Manual 1175.6632.02 ─ 30
Operation Time / h ← Counter
Displays the operation time in hours so far.
Remote command:
:DIAGnostic:INFO:OTIMe? on page 870
Power On Count ← Counter
Displays the number the instrument has been turned on.
Remote command:
:DIAGnostic:INFO:POCount? on page 870
Last Factory Calibration ← Counter
Displays the date of the last factory calibration.
Remote command:
:CALibration:DATA:FACTory:DATE? on page 865
15.7.2 Versions/Options Settings
Access:
► Select "System Config > Setup > Instrument Assembly > Versions / Options".
The "Versions/Options" dialog shows the version of the installed instrument firm-
ware, the hardware and software options, the data sheet and the software compo-
nents of the firmware. The BIOS version is also listed; firmware updates do not
update the BIOS version.
The remote commands required to query the hardware configuration are described in
Chapter 14.10, "DIAGnostic Subsystem", on page 868.
Firmware
Shows the firmware version and the version of the software platform.
Note: Your instrument is delivered with the latest firmware version available.
Requesting Instrument Configuration and Specifications
To Next Page
Loading...