Elements and Controls of the Graphical User Interface
R&S
®
SMW200A
1297User Manual 1175.6632.02 ─ 30
Routing
Denotes merged baseband signals.
Access to the "Baseband Offsets" dialog
Graphics indicator
Indicates that the corresponding signal is graphically shown.
The symbol covers the identifier of the signal source and is assigned to the corre-
sponding signal line. Digital signals are highlighted green, and the analog signals are
blue.
Connectors
Connector icons represent the interfaces for signal input and output. The symbols cor-
respond to the hardware connectors on the instrument.
The connectors are always bound by a function block and labeled with the
respective signal name. When you select a connector icon, you can fold the block and
the icon, or unfold (toggle mode). In the unfolded state, small LEDs show you whether
the signal is active or not.
Table C-1: Indication of connectors
Connector icon Denotes Folded view
Digital I/Q signal input (CODER
board)
Digital I/Q output (DAC board)
Analog I/Q input -
Analog I/Q output
RF output -
The LEDs indicate:
●
that a signal is active at the corresponding connector.
●
that a signal source is not active.
Elements in the Block Diagram
To Next Page
Loading...