Signal Routing and System Configuration
R&S
®
SMW200A
174User Manual 1175.6632.02 ─ 30
1 = Digital output interface state: gray = inactive; blue = active
2 = More settings indication; select to unfold detailed information
1. Select the connector icon to unfold the settings and retrieve more information on
the mapped streams and configured connectors.
21 3
4
Figure 4-16: Digital output interface DIG I/Q in advanced mode
1, 3 = Digital output interface state: gray = inactive; blue = active
2 = Digital connector name
4 = Mapped I/Q streams
The indication and access to the settings of the HS DIG I/Q interfaces follow the
same principle. Merely the connector indication changes.
Note: The number of the displayed digital output interfaces corresponds to the
number of enabled Streams (Rx Antennas) in the "System Configuration > Fading/
Baseband Configuration" dialog.
2. To (re) route the I/Q streams to the digital outputs, select the "I/Q Stream Mapper"
block.
3. To enable the baseband signal at the digital outputs, select "Block Diagram > I/Q
Digital > I/Q Digital > On".
4. To access the dialog box for configuring the digital output signal, select "I/Q Digital
> I/Q Digital Outputs".
I/Q Digital Output Settings
To Next Page
Loading...