Signal Routing and System Configuration
R&S
®
SMW200A
197User Manual 1175.6632.02 ─ 30
8. Select "Apply".
The "System Config > System Configuration > External RF und I/Q" dialog displays
the settings of the connected external instrument.
9. You can disable "RF Couple" state and adjusts the RF settings manually.
In a MIMO setup however, it is useful to use the coupled settings, because a MIMO
setup typically requires the same RF frequency at all antennas.
10. Perform the previous steps to connect and configure the second R&S SGS.
11. Select "I/Q OUT 1 > External Instrument > Config".
Select "Remote Config > Initialization Sequence" and load a file with file extenssion
*.iec.
Tip: Try out also "To create a remote control sequence or modify the initialization
sequence" on page 203.
How to Connect External Instruments and Configure the Signal Flow
To Next Page
Loading...