Monitoring Signal Characteristics
R&S
®
SMW200A
637User Manual 1175.6632.02 ─ 30
a) Select "Marker > Marker 2 > On/Off Ratio", "On Time = 16 MSamples", "Off
Time = 16 MSamples".
The signal "Marker 2" determines the repetition window; the selected "On
Time" is long enough so that the measurement captures several gates defined
by the "Marker 3" signal.
b) Select "Marker Mode > Marker 3 > Frame Active Part" and "Frame Block Index
= 2".
c) Select "Marker Delay > Marker 3 > 5 Samples" to make sure that this marker
signal is within the measurement period.
4. Select "IEEE 802.11 WLAN > General > State > On".
Querying Information on the Baseband Power Levels
To Next Page
Loading...