Getting Started
R&S
®
SMW200A
65User Manual 1175.6632.02 ─ 30
described in Chapter 3.3.3, "Triggering the Instrument with an External Signal",
on page 57.
The minimum requirement for the instrument in this example is an R&S SMW equipped
with the options 2xR&S SMW-B10, R&S SMW-B13T, and R&S SMW-B1003/-B2003.
To configure a composed baseband signal
1. In the first baseband, generate a WCDMA-3GPP signal as described in Chap-
ter 3.3.2, "Generating a Digitally Modulated Signal", on page 55.
2. To route the signal from "Baseband B" block to the first signal path, use one of the
alternatives:
● In the block diagram, select "Baseband B" block and drag&drop it to the first
path ("Fading A" block or "AWGN A" block depending on the options installed
on your instrument).
Select the "Fading B" block and drag&drop it to the "Baseband B" block.
● In the block diagram, select "Baseband B" block, navigate in the context menu,
and select "Signal Routing > route to path A".
The block diagram displays the routing.
Trying Out the Instrument
To Next Page
Loading...