Rohde & Schwarz R&S SMW200A - Page 66

Getting Started
R&S
®
SMW200A
66User Manual 1175.6632.02 ─ 30
3. In the block diagram, select "Baseband B > Misc > Custom Digital Mod...", select
"Set acc. to standard > 3GPP FDD" and enable "Custom Digital Modulation > State
> On".
4. To apply frequency and power offsets to the signals, select "Baseband B > Base-
band Offsets".
a) Enter "Baseband A > Frequency Offset > 5 MHz".
b) Enter "Baseband B > Frequency Offset > -5 MHz".
c) Enter "Baseband B > Path Gain > -30 dB".
d) Close the "Baseband Offsets" dialog.
Trying Out the Instrument